A microfluidic device using a green organic light emitting diode as an integrated excitation source

A simply fabricated microfluidic device using a green organic light emitting diode (OLED) and thin film interference filter as integrated excitation source is presented and applied to fluorescence detection of proteins. A layer-by-layer compact system consisting of glass/PDMS microchip, pinhole, excitation filter and OLED is designed and equipped with a coaxial optical fiber and for fluorescence detection a 300 microm thick excitation filter is employed for eliminating nearly 80% of the unwanted light emitted by OLEDs which has overlaped with the fluorescence spectrum of the dyes. The distance between OLED illuminant and microchannels is limited to approximately 1 mm for sensitive detection. The achieved fluorescence signal of 300 microM Rhodamine 6G is about 13 times as high as that without the excitation filter and 3.5 times the result of a perpendicular detection structure. This system has been used for fluorescence detection of Rhodamine 6G, Alexa 532 and BSA conjugates in 4% linear polyacrymide (LPA) buffer (in 1 x TBE, pH 8.3) and 1.4 fmol and 35 fmol mass detection limits at 0.7 nl injection volume for Alexa and Rhodamine dye have been obtained, respectively.     

Statistics aided optimization for high-performance liquid chromatographic analysis of organic acids in tobacco

HPLC analysis for organic acids in tobacco was optimized with the aid of statistical experimental design, a central composite face-centered design. In the design, only thirteen HPLC analyses were needed for identifying two optimal separation parameters. A Bio-Rad Aminex HPX-87H column was used for the analyses. An optimal separation for seven acids in tobacco was found at a temperature of 57 degrees C and a mobile phase of 0.032 N sulfuric acid solution, or at a temperature of 70 degrees C and a mobile phase of 0.024 N sulfuric acid solution, with a flow rate of 0.6 ml min(-1).     

新型含金属元素二胺的合成与表征

本文分别用液相法和固相法合成了一系列含不同金属元素的二胺,并通过红外光谱,~1HNMR、~(13)CNMR,紫外光谱,电化学分析及元素分析对其进行表征,还通过DSC和TG对其热性能进行了研究,结果发现这些二胺具有良好的耐热性,是合成一些耐热高聚物的优良原料.     

Cyanex272-P507浸渍树脂协同萃取色层分离铥镱镥的研究

以Cyanex272-P507浸渍树脂采用萃取色层法对铥镱镥富集物进行了吸附和淋洗分离研究,考察了淋洗剂浓度、稀土负载量、淋洗液流速等因素对分离铥镱镥富集物的影响。结果表明,在充填的树脂粒度为0.3~0.6 mm的色层柱中,以0.2 ml.cm-2.min-1进料流速时能得到较大的吸附率;在稀土负载量为树脂重量的0.6%,淋洗液流速为1.0 ml.cm-2.min-1,温度为30℃,装柱树脂高度为400 mm(高径比为25∶1)的条件下,用1.0,1.5,2.0 mol.L-1盐酸梯度淋洗Tm,Yb,Lu,可实现铥镱镥富集物三者的完全分离。     

Study of the Complexation Behavior of Calixarene with Transition Metal Cations by UV—vis and Fluorescent Spectra

A new fluorescent compound based on calix[4] arene skeleton was synthesized.Its complexation ability with transition metal ions,such as Fe^3 ,Co^2 ,Ni^2 ,Cu^2 ,Zn^2 and Ag^ ,Was investigated by UV-vis and fluorescent spectra.     

Synthesis and Characterization of Novel Orange-emitting Iridium（Ⅲ） Complexes with Diphenylquinoline Ligands Containing Fluorinated Substituent

Three new cyclometalated iridium（m） complexes based on ligands of diphenylquinoline with fluorinated subsfituents were prepared, and characterized by elemental analysis （EA）, ^1H NMR, and mass spectroscopy （MS）. The photophysical and electrophosphorescent properties of the complexes were briefly discussed.     

甲醇与乙醇一步合成异丁醛用CuO-ZnO/Al2O3催化剂

在ＣｕＯ－ＺｎＯ／Ａｌ２Ｏ３催化剂上，甲醇与乙醇在常压和２１０￣３６０℃温度下一步反应合成异丁醛。利用正交设计方法，研究了ＣｕＯ－ＺｎＯ／Ａｌ２Ｏ３体系催化剂组成和制备条件等因素对催化剂催化性能的影响。结果表明，催化剂中ＣｕＯ含量对催化剂的催化活性影响最大，而ＺｎＯ含量则主要影响催化剂对异丁醛的选择性。催化剂制备条件，如沉淀温度、陈化时间等，也不同程度也影响催化剂的催化性能。ＸＲＤ和ＢＥＴ表征结果     

四种溴代甲苯异构体的质谱区分

本工作用四种较新的质谱技术(碰撞诱导解离(CID),电荷剥离(CS),电荷分离(CSe),电子捕获诱导解离(ECID)谱研究了邻、间、对溴甲苯和溴化苄四种异构体。四种技术在一定程度上都可区分这些异构体。其中比较四种异构体ECID谱中ECID峰的相对强度可得到满意的区分效果。     

高效毛细管电泳间接紫外检测血浆中钾、钙、镁

用高效毛细管电泳法,在pH 5.5的缓冲介质中用酒石酸作为络合剂,使血浆中钾、钠、钙、镁4种阳离子达到很好分离,用咪唑作为背景试剂进行了紫外检测.对电泳分离及紫外检测的各分析条件(包括背景缓冲溶液的pH值,咪唑溶液的浓度及酒石酸溶液的浓度等)作了试验并予以优化,上述4种离子的相互分离在4.5 min内顺利完成.文中给出了K 、Ca 、Mg2 的线性回归方程,其相关系数在0.998 4～0.999 4之间,证明了在各离子的峰面积与其浓度之间呈线性关系,3种离子的检出限(S/N=3)依次为0.20,0.12,0.06 mg·L-1.用迁移时间检测和用峰面积检测所得的RSD值(n=6)依次小于0.76%和2.83%.由于钠离子的吸收峰与系统峰重叠,钠的测定无法进行.回收率试验的结果在95.3%至104.2%.     

ADSORPTION OF 2,4-DICHLOROBENZOXYACETIC ACID ONTO HYPERCROSSLINKED RESIN MODIFIED BY PHENOLIC HYDROXYL GROUP (AM-1)

INTRODUCTIONAdsorption has been considered to be the best available technology for removing organics from water in the USSafe Drinking Water Act[1]. Due to many drawbacks of activated carbon[2-7], the most widely used adsorbent,hypercrosslinked polymeric adsorbents developed by Tsyurupa and Davankov[8] have been increasingly viewedas an alternative to activated carbon for selective removal of specific organic substances from contaminatedwater[9-12], and series of researches have been do…